XR30CX-5N1C1 Digital Thermostat Controller Off Cycle Defrost AUX Relay 230V/50Hz-60Hz Programmable-Commercial for Refrigeration

Model XR30CX,format 32 x 74 mm,is a digital thermostat with off cycle defrost designed for refrigeration applications at normal temperature. It provides two relay outputs, one for the compressor, the other one can be used as light, for alarm signalling or as auxiliary output It is also provided with 2 NTC or PTC probe inputs, the first one for temperature control, the second one, optional, to connect to the HOT KEY terminals to signal the condenser temperature alarm or to display a temperature. The digital input can operate as third temperature probe. The HOT KEY output allows to connect the unit,by means of the external module XJ485-CX,to a network line ModBUS-RTU compatible such as the Dixell monitoring units of X-WEB family. It allows to program the controller by means the HOT KEY programming keyboard.The instrument is fully configurable through special parameters that can be easily programmed through the keyboard. Suitable for appliances including. for refrigeration applications at normal temperature. Specification Housing:self extinguishing ABS. Case:XR30CX frontal 32x74 mm;depth 60mm; Mounting:XR30CX panel mounting in a 71x29mm panel cut-out Protection:IP20;Frontal protection:XR30CX IP65 Connections:Screw terminal block ± 2,5 mm2 wiring. Power absorption:3VA max. Display:3 digits,red LED,14,2 mm high;Inputs:Up to 4 NTC or PTC probes. Digital input:free voltage contact Relay outputs:compressor SPST 8(3) A,250Vac;or 20(8)A 250Vac DEFROST Defrost is performed through a simple stop of the compressor.Parameter IdF controls the interval between defrost cycles,while its length is controlled by parameter MdF. Package Include 1 X Dixell XR30CX Digital Thermostat Controller

• It is a digital thermostat with off cycle defrost designed for refrigeration applications at normal temperature. It provides two relay outputs, one for the compressor,the other one can be used as light, for alarm signalling or as auxiliary output.
• The regulation is performed according to the temperature measured by the thermostat probe with a positive differential from the set point: if the temperature increases and reaches set point plus differential the compressor is started and then turned off when the temperature reaches the set point value again. In case of fault in the thermostat probe the start and stop of the compressor are timed through parameters COn and COF.
• Defrost is performed through a simple stop of the compressor. Parameter IdF controls the interval between defrost cycles, while its length is controlled by parameter MdF.Case,XR30CX frontal 32x74 mm; depth 60mm;
• SAFETY PRECAUTIONS Check the supply voltage is correct before connecting the instrument. Do not expose to water or moisture: use the controller only within the operating limits avoiding sudden temperature changes with high atmospheric humidity to prevent formation of condensation. Warning: disconnect all electrical connections before any kind of maintenance. Fit the probe where it is not accessible by the End User. The instrument must not be opened.
• In case of failure or faulty operation send the instrument back to the distributor or to Dixell S.r.l.(see address) with a detailed description of the fault. Consider the maximum current which can be applied to each relay (see Technical Data). Ensure that the wires for probes, loads and the power supply are separated and far enough from each other, without crossing or intertwining.